Upcycle Project – Dining Chairs(Part 4)

I’m finally on the last part of the posts about my dining chair upcyle project (Part 1, 2 and 3 can be found in the following links – Part 1, Part 2 and Part 3 ) and today I will be sharing the finishing touches that I have added, lessons I have learned and how much the project cost per chair.

Firstly though, the finished chairs…

I finally finished the chairs, it took several weekends to complete but I’ve done it and am really pleased with the outcome!  The final finishing touch that I have added is some pompom trim that I used for the alcoves when I decorated the downstairs which I purchased from Amazon (if you missed that post you can find it here) .  I decided to add the trim to add a further element of co-ordination into the colour scheme and design of the room and I feel that it pulls all the elements together really well.  I like the idea that people will notice all the little touches and will allow their eye to investigate the room in greater detail.

This chairs project was really my first major foray into the world of upcycling and upholstery.  I have not worked on a project quite like this before and along the way have learned a few lessons…

  1. However long you think it will take, double it and add an hour.  Sanding the chairs was probably the longest part and I couldn’t believe how much time I spent clearing the old varnish from the frames of the chairs.
  2. Clearing all the varnish and stripping the frames back to bare wood is the best thing to do for the paint to adhere properly.  Failing to clear all the varnish, like on my yellow chair, has resulted in patchy paint and the colour of the varnish bleeding through all the coats of paint I applied.  It still looks patchy now and seems to be more noticeable at the bottom of the legs.
  3. Sometimes it pays to sit back and think a bit…I tried to create a fancy curved corner and edge on the first seat that I tried to upholster which didn’t really work and frustrated me when it didnt go to plan.  I should have sat and thought about what I was doing and ways to cover the seat before starting.
  4. Have fun with your project.  Think about what is fun and makes you smile and go with what you think will work.  The worst that can happen with a project like this is that you have to sand the chair down and start again.

And here are the costing calculations on the attached document…

Costings for chairs

So, in all the chairs cost £17.63 to upcycle which doesn’t seem too bad when you consider that I have bespoke, one of a kind, unique chairs that fit my home and style perfectly and I have had the experience of learning new skills along the way.  And I’m proud to show them off and say “I created these”.  I would recommend to anyone that can’t seem to find furniture that they completely like or keep finding thing that are not quite right to go out and see what is available for sale second-hand and try your hand at creating something that you love!

 

Upcycle Project – Dining Chairs (Part 2)

In last weeks post I told you guys about my dining chair find and the idea I had for upcycling them, todays post is about prepping them and painting them.

I decided that I was going to paint the chairs in different colours and change the seat fabric to white instead of going with white chairs and coloured seats.  I wanted to match the colours of the chairs to storage boxes in my dining area – pink, blue, yellow and white, however, I thought that having one fully white chair may look a bit odd but I was not really sure what colour paint to choose instead.  I decided to head to B&Q and see what sort of colours they had and what stood out to me.  I chose B&Q Colours range and bought tester pots in Playful Pink, Buttercup Yellow, Tropez blue, and lastly, instead of white I chose Green Apple.

Before painting I needed to prep the chairs by removing the varnish from them so that the paint would adhere properly.  Unfortunately I learned this the hard way as all I did for the first chair I painted was to “rough up” the varnish rather than remove it completely, the paint didn’t take very well and still, in certain lights looks patchy now.  I decided to remove the seat to make the process of sanding a bit easier and managed to remove the seat from the chair frame fairly easily, all I needed to do was flip the chairs upside down and undo 5 screws then lift the seat off.  Once the seat was off I was able to start sanding the chair frame down.  I used an 80 grit sandpaper and sanded each chair back to the wood in the garden.  Sanding is a lot messier than I anticipated and after being covered with dust and having to wash so many clothes I figured it would be better to wear my overalls for the job!  I worked on one chair at a time so that the screws and seats didnt become muddled as I wasnt sure if all the screw holes would match up on each chair.

There are a few things I learned about sanding while undertaking this part of the project (aside from wearing overalls…) and one of them is to sweep up immediately after you have finished otherwise the fuzzy “helper” will go and lie in the dust you have created and get covered!  The other thing I learned was that sanding is a lot more time-consuming than you imagine!  I had expected to clear the varnish from one chair in around an hour… in reality it took more like 4 hours to remove all the varnish per chair.

Once the sanding was finished I was able to start painting.  I started with the yellow first as I was going to be using the same brush for all chairs and washing it out between colours.  Starting with the lightest colour first means that there is less likelihood of paint to be ruined through colour contamination should the brush not be cleaned thoroughly.

This slideshow requires JavaScript.

Aside from the yellow chair needing several layers of paint and still being patchy now (due to the varnish not being stripped completely) I’m pretty happy with how the chair frames turned out and the paint colours I had chosen.  The paint is a matt finish and I used 3 tester pots per chair, did 2 to 3 coats per chair (the yellow chair took 5 pots and a lot more coats of paint) and they were fully dry by the following morning, touch dry within 20 minutes.

Next week I will be sharing the upholstering part of this project!

Pulling the Room Together

As promised, this is the second post about decorating my downstairs room and the extra decoration I have added.

After painting and leaving the walls to dry for a time I decided to add some fun touches and textural interest to the arches and alcoves in the form of multi-colour pompoms.  I measured the alcoves and archway and searched the internet for what I had in mind…. I eventually found what I wanted from Amazon .  I was able to purchase this in long lengths which was what I was looking for, each length had to be more than a meter so I could run a continuous length rather than fixing lengths together to fit into the alcoves.

I bought some Command Hooks from B&Q that are meant for hanging decorations such as Christmas Lights, to hang the trim up.  Command Hooks are able to be used and removed without harming the wall underneath and, having used several of their other products in the past, decided that these would be the best thing to use.  The hooks were a bit fiddly as they come in a pack – the hooks all connected to one another and the sticky part separate.  You need to break off the hooks and attach the correct side of the sticky to the hook before peeling the other side from the sticky and attaching to the wall.  I found it easier to break off all the hooks and then attach the sticky to them all before using.

I placed the hooks up the alcoves at equal distances but alternating the facing of the hook, so one faced towards the wall, the next at 180 degrees and facing away from the wall before weaving the trim up and through each hook.

I was really worried that upon the trim being delivered it wouldn’t be as bright as I’d wanted or, not even the correct thing at all (going by past experiences…) and worried that the overall effect would not be like I imagined.  I’m really pleased with how it turned out though, and it always makes me smile.  Visitors to my home have commented on how nice it looks so I’m guessing that it’s not just a hit with me!

Here’s some pictures of the room with the trim up!  (please note that some of these photos are really recent ones…)